General Coolant hose protection from chafing

255/85 said:

I also fitted some wear protection mostly on the smaller lines. I then created a few makeshift supports from heavy zip ties for sections of hose that seemed too little supported but didn't require flexibility to function. I use three ties to do this - one zip tie around a stationary part (or nearby hose), another around the loose/floppy hose or line, and a third joining them together. There are some coolant line connections that make no sense to me and are in very difficult-to-service places so I rotated any hose clamps into accessible positions so I can remove them in the future without a prehensile tail or three hands.

Click to expand...

parb said:

Seems like someone should make a kit for it

Click to expand...

Dokatd said:

Yeah like maybe Ineos? And they should provide it installed free of charge

Click to expand...

parb said:

I don't expect Ineos to do much until it's demonstrated that there is an issue. I'm okay with the aftermarket going above and beyond for extra protection.

Click to expand...

C-Mack said:

After getting to know my Grenadier a bit more and inspecting in the engine compartment (petrol version), I’ve noticed a few coolant hoses run very close to sharp edges or other components which over time with vibration and heat expansion could cause a hose to chafe and leak. I’ve also noticed hose routings in some parts of the engine compartment, especially between main radiator fan shroud and engine front face have a bit of a prototype look to them and are being held in place by what look like non-factory zip-ties in odd locations. Could it be pre-delivery remediation by the dealers after Ineos has noticed a production issue?

Just for piece of mind in a few locations I decided to cover the hoses with a protective wrap. I ran across a product called Dura Wrap (can be cut to any length you need) and it is available in a few different sizes. The hoses I was most concerned about were the 1” (25mm) ones which seem to run everywhere in the engine compartment and put wrap around spots where chafing was likely to occur especially with the added vibration encountered off-road. I can’t see that it will hurt anything to have a little added protection in spots so here is a link to the wrap I used and a few pictures of it installed if anyone is interested.

Dura Wrap Heavy Duty Braided Sleeving

Dura wrap heavy duty braided sleeving is a extremely durable ballistic nylon side entry wrap around cable and hose sleeving for industrial and heavy duty uses.

www.cabletiesandmore.com

Click to expand...

richardknight said:

There is an additional problem with the coolant hose connectors. I’ve just hit 9400 miles on my MY23 petrol grenadier and had a failure of one of the coolant hose connectors. Looks like the plastic connecter has degraded ( it appears the plastic has turned to a soft powdery texture and the connector just snapped.) Coolant spraying all over the place, luckily I was only on a short trip near home. I’m now waiting for the next connector to fail. Dealer said he’s never had to fix a problem with the coolant hose connectors. I requested a replacement with a metal connector but they want to exchange it with another plastic one. Hmmmm….WTF .

Click to expand...