did you get it back in?In the passenger footwell.
did you get it back in?In the passenger footwell.
Finally Global Grenadier medallions arrived yesterday - 9 days US to Brisbane - 18 days for the last 50 odd kms! Apparently they had a trip to Darwin in the meantime.seems par for the course.... our regular postie was saying last week that they (Qld Aus. Post) are desperately short staffed and he's been taking extra shifts while he can before Uni begins late Feb. (he's a part time law student!!)
Hopefully the medallions didn’t make you barf?Finally Global Grenadier medallions arrived yesterday - 9 days US to Brisbane - 18 days for the last 50 odd kms! Apparently they had a trip to Darwin in the meantime.
Hi Krabby, Are these the original ones or the ones that have been painted or enameled or the ones to fit where the compass goes? I have 2 of the original ones. If these are the painted or enameled ones, I will take one.Hopefully the medallions didn’t make you barf?
NO, very happy with medallions - just our crappy postal service - it’s enough to make anyone chuck up!Hopefully the medallions didn’t make you barf?
Still the original all metal engraved one. We're waiting on a sample of the painted ones before moving forward. There's a bit of a greater upfront cost on those and we need to make sure they're perfect before we can sell them.Hi Krabby, Are these the original ones or the ones that have been painted or enameled or the ones to fit where the compass goes? I have 2 of the original ones. If these are the painted or enameled ones, I will take one.
Thanks, DaBull
Spoke to my dealer ( who is relatively local) and they had just done the one, but he said may not be as straightforward as putting the pin back in and may need new selector. So giving it to him to sort.did you get it back in?
Vielen Dank. Sehr schön.Went to an island in the NorthSea this morning
View attachment 7843089View attachment 7843090View attachment 7843091
Yes, there is one screw behind the lever itself, you only need to remove again the lever to see it if I remember well.I dug out the INT1 wires which were taped so far down I had to remove the dead pedal. Had the dash half open at that point anyway so I cleaned up the Wolfbox wiring.
View attachment 7843372
At the end I had an extra screw. Can't figure out where it went. Big guy like the one holding the bonnet lever. Will be opening it up at some point again to wire something in, so I'll save the exploration for another day.
View attachment 7843371
I have one there but maybe it should be the long one making my extra one of the small ones. I think it goes into the bottom trim somewhere. The one I have is longer so it should affix to either the left wall or the floor.Yes, there is one screw behind the lever itself, you only need to remove again the lever to see it if I remember well.
[EDITED] Found a picture I made in June last year, but as the trim is clipped, it doesn't matter:
View attachment 7843383
Easy and simple.Taped an tied the selector so pin stays put - I hope. Thanks to those who had flagged it's wandering ways
So "Adam" from NA had this happen on his drive from WA state across country back to the east Coast. He used a zip tie to keep it in place. I don't think the selector was replaced. Message him for more details.Spoke to my dealer ( who is relatively local) and they had just done the one, but he said may not be as straightforward as putting the pin back in and may need new selector. So giving it to him to sort.