What's new
The Grenadier Forum
Register Now for enhanced site access.
INEOS Agents, Dealers or Commercial vendors please contact admin@theineosforum.com for a commercial account.

What did you do with your Grenadier today?

Loc Nar

Loc Nar

Grenadier Owner
Lifetime Supporter
Local time
10:50 AM
Joined
Apr 28, 2022
Messages
498
Reaction score
969
Location
Alabama, USA
Great stuff! Thanks. I have homework and am looking forward to it. And you should be writing Victron's installation guides!

And reading the more detailed installation manual confirmed @anand's helpful advice:

3.4. Basic electrical connections Connection procedure:

1. Connect the negative battery terminal to the M10 bolt on the "BATTERY MINUS" side of the shunt. Tighten the shunt bolt with a maximum torque of 21Nm. Note that there should be no other connections on this side of the shunt or on the negative battery terminal. Any loads or chargers connected here will be excluded from the battery state of charge calculation.

2. Connect the negative of the electrical system to the M10 bolt on the "LOAD MINUS" side of the shunt. Tighten the shunt bolt with a maximum torque of 21Nm. Make sure that the negative of all DC loads, inverters, battery chargers, solar chargers and other charge sources are connected “after” the shunt.

3. Connect the M10 eye terminal of the red cable with the fuse to the positive terminal of the battery. The battery monitor is now powered up.
Click to expand...
 
Last edited:
Nadir5

Nadir5

Grenadier Owner
Local time
8:50 AM
Joined
Jan 25, 2024
Messages
58
Reaction score
55
Location
Los Angeles, CA, USA
parb said:
Today I got my compressor installed. A tjm pro with the catuned bracket.
You can barely see it on the right side in the photo.
I also updated my old psi meter for this digital inflator/deflator from morrflate. Both works perfect!

Pro tip. 20ft hoses are the right length for this vehicle.
View attachment 7872557
Click to expand...
I tried installing my TJM kit today. The bracket is straightforward enough (and yes it’s tight, but you don’t need to lift the vehicle to pull the fender liner, if you still have stock tires). The supplied wiring loom, on the other hand, is a hot mess - way too much wire for the application in a Grenadier, and no Grenadier-specific instructions on wire routing (the CA Tuned YouTube video is not helpful in this area). Going to try again another day, likely cutting a lot of wires and crimping on new connections to shorten it all up.
 
S

Steve A

Lifetime Supporter
Local time
10:50 AM
Joined
Aug 20, 2024
Messages
33
Reaction score
41
Location
Grapevine, TX, USA
I got my steps installed

stepsSm.jpg
 
parb

parb

Grenadier Owner
Lifetime Supporter
Local time
8:50 AM
Joined
Sep 10, 2023
Messages
947
Reaction score
1,381
Location
Silicon Valley, CA, USA
I got the tjm pro installed last Tuesday with the catuned bracket.
I used it a lot in Moab. I paired it with a morrflate air hub and I filled two tires at once. You need 20ft hoses for a comfortable setup.

The setup performed super well in Moab, bot inflating and deflating my tires.
One of the best investments I've made. I really like that setup.
I had warner ineos install it as I was short on time going to Moab.
 
Last edited:
Tom D

Tom D

Grenadier Owner
Lifetime Supporter
Local time
4:50 PM
Joined
Jun 3, 2022
Messages
991
Reaction score
2,738
Location
Berwickshire
I washed mine today in preparation for reapplying lanoguard and an oil service.
 
rovie

rovie

Grenadier Owner
Lifetime Supporter
Local time
11:50 AM
Joined
May 19, 2022
Messages
2,128
Reaction score
3,999
Tom D said:
I washed mine today in preparation for reapplying lanoguard and an oil service.
Click to expand...
I always wash my vehicles before I take them to the garage too. I think it's outrageous when people just park their mud-covered vehicles and expect the workshop staff to scrape off the dirt before they get to the bolts.
 
Tom D

Tom D

Grenadier Owner
Lifetime Supporter
Local time
4:50 PM
Joined
Jun 3, 2022
Messages
991
Reaction score
2,738
Location
Berwickshire
rovie said:
I always wash my vehicles before I take them to the garage too. I think it's outrageous when people just park their mud-covered vehicles and expect the workshop staff to scrape off the dirt before they get to the bolts.
Click to expand...
Well I’m doing it myself so definitely going to clean it!
 
anand

anand

Photo Contest Winner
Forum Moderator
Grenadier Owner
Lifetime Supporter
Local time
11:50 AM
Joined
Mar 12, 2023
Messages
3,003
Reaction score
4,879
Location
Maryland
YIPPE said:
Do these auto pair on rotations once on the car? Also how many $$/€€/££ for a sensor and a new steel wheel?
Click to expand...
They don't auto pair, but if you purchase the programmer you can reprogram the sensor instead of having to reprogram the vehicle.

In the US the sensors sell for around $30USD/ea
 
D

Dok

Grenadier Owner
Local time
5:50 PM
Joined
Jun 15, 2024
Messages
111
Reaction score
159
Location
France
YIPPE said:
Do these auto pair on rotations once on the car? Also how many $$/€€/££ for a sensor and a new steel wheel?
Click to expand...
They don't auto pair.
You copy / clone existing sensors so the car doesn't make any difference when you switch tires

Sensor
Unit price is around € 28
https://autel-france.com/fr/autel/269-valve-aluminium-tpms-universelle-programmable-433-315-mhz.html

Device
Around € 300
My dealer offer me to do it so I don't have to buy the device

Steel wheel
€ 300 if I ask the dealer
I did pay the € 100 but now a little more:
https://www.pneustore.fr/jante_info.php?products_id=229276
 
Tom D

Tom D

Grenadier Owner
Lifetime Supporter
Local time
4:50 PM
Joined
Jun 3, 2022
Messages
991
Reaction score
2,738
Location
Berwickshire
2nd oil service done today, Lanoguard reapplied. I was impressed with the performance of the Lanoguard. That was the first time I had seen the car up on a hoist since I did it last year, it had rubbed off in a few low slung places that occasionally rub the ground / vegetation like the front bash plate and the bottoms and bolts of the lower control arms but it was still impressive. There is no rust on any of the bolt heads or threads. The bolts for the side steps which were added after Lanoguarding have rusted, so it definitely makes a difference. They have now been done too of course.
 
ECrider

ECrider

Grenadier Owner
Lifetime Supporter
Local time
4:50 PM
Joined
May 4, 2022
Messages
3,351
Reaction score
5,590
Location
UK
Tom D said:
2nd oil service done today, Lanoguard reapplied. I was impressed with the performance of the Lanoguard. That was the first time I had seen the car up on a hoist since I did it last year, it had rubbed off in a few low slung places that occasionally rub the ground / vegetation like the front bash plate and the bottoms and bolts of the lower control arms but it was still impressive. There is no rust on any of the bolt heads or threads. The bolts for the side steps which were added after Lanoguarding have rusted, so it definitely makes a difference. They have now been done too of course.
Click to expand...
what mileage are you up to Tom D?
 
Dual Grenny Guy

Dual Grenny Guy

Grenadier Owner
Lifetime Supporter
Local time
10:50 AM
Joined
Jul 10, 2024
Messages
523
Reaction score
600
Location
Louisiana, USA
Tom D said:
2nd oil service done today, Lanoguard reapplied. I was impressed with the performance of the Lanoguard. That was the first time I had seen the car up on a hoist since I did it last year, it had rubbed off in a few low slung places that occasionally rub the ground / vegetation like the front bash plate and the bottoms and bolts of the lower control arms but it was still impressive. There is no rust on any of the bolt heads or threads. The bolts for the side steps which were added after Lanoguarding have rusted, so it definitely makes a difference. They have now been done too of course.
Click to expand...
I’m in the US and never heard of “Lanoguard”. I had to google it and found more info on it. Going to see if any local places to similar things. I have PPF & ceramic coating done on all my newer vehicles, but have never had the undercarriage sprayed or however applied. See, learnt me something new today from this awesome forum!! 👍🙌
 
Tom D

Tom D

Grenadier Owner
Lifetime Supporter
Local time
4:50 PM
Joined
Jun 3, 2022
Messages
991
Reaction score
2,738
Location
Berwickshire
ECrider said:
what mileage are you up to Tom D?
Click to expand...
26000.
The dealer never had an air filter in stock so I’ll get the service reminder reset done when i go in to get the filter. The workshop manual would have saved me a few minutes here and there, like finding the cabin filter and not having to google BMW oil change procedure. It was all very easy though.
 
Tom D

Tom D

Grenadier Owner
Lifetime Supporter
Local time
4:50 PM
Joined
Jun 3, 2022
Messages
991
Reaction score
2,738
Location
Berwickshire
Dual Grenny Guy said:
I’m in the US and never heard of “Lanoguard”. I had to google it and found more info on it. Going to see if any local places to similar things. I have PPF & ceramic coating done on all my newer vehicles, but have never had the undercarriage sprayed or however applied. See, learnt me something new today from this awesome forum!! 👍🙌
Click to expand...
Rust is likely much less of a problem for you guys, up here we spread salt on the roads 6 months of the year and we have a very damp climate.
I was casually browsing the classified adds the other day looking for an old Nissan Patrol or an 80 series Land Cruiser there are hardly any left. All eaten by rust. In Australia they have loads left..
 
Dual Grenny Guy

Dual Grenny Guy

Grenadier Owner
Lifetime Supporter
Local time
10:50 AM
Joined
Jul 10, 2024
Messages
523
Reaction score
600
Location
Louisiana, USA
Tom D said:
Rust is likely much less of a problem for you guys, up here we spread salt on the roads 6 months of the year and we have a very damp climate.
I was casually browsing the classified adds the other day looking for an old Nissan Patrol or an 80 series Land Cruiser there are hardly any left. All eaten by rust. In Australia they have loads left..
Click to expand...
Dang yall love yall some salt on the other side of the pond!! 😳🙃😎
 
You must log in or register to reply here.

Similar threads

Annee Grenadier_girl
What would you say if you could ?
2 3 4
Replies
73
Views
3K
Zimm
Zimm
Bruce B
Today was a big day…❤️
Replies
11
Views
914
LeeroyJ
LeeroyJ
Mad Hatter
What is this cup thing that came with my new grenadier?
2
Replies
21
Views
894
CrazyOldMan
C
Bruce B
Honey, look what followed me home!
Replies
9
Views
847
Voader - Oudersopzwier
Voader - Oudersopzwier
Mad Hatter
Europe Model year differences and how do I know what model year my vehicle is?
Replies
14
Views
720
Eric
Eric
Forum Store
The officially unofficial podcast for INEOS Automotive Grenadier Works Podcast
INEOS Grenadier Configurator

Latest posts

Share this page

Back
Top Bottom