20 INCH LIGHTBAR ON TOP LOOP OF THE ROO BAR?
I have been working on a little project for a few weeks now. I find out tomorrow whether it will work.
I was going to install a 10-inch low profile LED Lightbar under the top loop of the Roo Bar (in NSW it is illegal to mount then above the Roo Bar – even though people do it).
After some research I am now trying to mount a 20-inch lightbar there instead– it will either just fit or not fit. It is so close we need to do an actual test fit.
I needed low profile mounting brackets, which I now have and I have done a test bracket fitting. I had worked out 3 ways to mount the 20-inch lightbar to the bracket, but after the test fitting 2 of those ways will not work. All 3 should work with a 10-inch lightbar. Power will come from the 10 amp bonnet circuit, with some other wiring.
I do not want my mounting brackets or lightbar to be an additional pedestrian risk, so everything must be behind or inline with the Roo Bar. When mounted, the Roo Bar slopes backwards from the bumper.
When I visit ORS tomorrow, we will try and fit the 20-inch lightbar, the worst-case scenario is we fit the 10-inch lightbar instead.
I could not locate many 15-inch lightbars with the right profile – I found one with a hefty price tag (over twice the price of the one I am buying). I want to reduce any interference with air flow to the radiator, so options are limited to single row, low profile lightbars.
I could probably mount the 20 inch lightbar down of the bumper, but with a winch installed, I do not want to drill holes or have bolts in the bumper anywhere near the winch.
Pictures of the sliders on his car 
