So far my winter experience has been pretty mild. No issues with traction or heating/cooling. It has been kinda mild here for a winter but we did get highs of only 63degrees. The heated seat worked great. 
What do you think the "factory trained" mechanics are going to do?
Zip it. Arizona is not allowed to discuss winter. Red flag for you, Captain Sunshine.So far my winter experience has been pretty mild. No issues with traction or heating/cooling. It has been kinda mild here for a winter but we did get highs of only 63degrees. The heated seat worked great.
Thump the handle and charge $595.
On the plus side, until you're out of warranty they are sending that bill (albeit half of the labor) to Ineos
Me too - but then @anand explained it in a previous post. Next time one sticks, leave it in - get down level with the handle and look carefully at the button (which should still be in the stuck depressed position). You should see the button slightly off center. In the case for me yesterday (rear passenger door - the usual culprit for me), it was touching the face at the “9:30” position - almost directly aft, and slightly up. We’re talking far less than 1mm so really take a good look with a flashlight. Then with a rubber mallet, you can hit the handle to ever so slightly adjust the face plate in the direction you need to create clearance. @anand said they did this on the whole fleet for the trial series tour and eventually had them all sorted out. He can correct me, but when I did the North Carolina event, it seemed like there were a good 15 or so Grenadiers. I’ve tried graphite and lubricant and took mine to the dealer. The “dad whack” seems to be the actual fix. @anand strikes again.
9, but close enough
Clearly, I was an overwhelmed man-child out of my mind with excitement9, but close enough
The West Coast tour had a separate 9 vehicles... and there were a few extras rotated in
I recall in Maryland, I was told they were pre production and stuff like… the door buttons and electronics were being sorted out.9, but close enough
The West Coast tour had a separate 9 vehicles... and there were a few extras rotated in
They were definitely pre-production... Although we found that the door buttons and electronics were normal MY23 spec; plenty of other stuff wasn't "quite" there yet on them
This. I drop my Gren off in a couple weeks for a small list of items. I didn’t add sticking door buttons. Is there an actual factory fix, or am I better off adjusting the two wet-sticky buttons with a rubber mallet? No sense I asking the dealer to spend a bunch of time to put the same parts back in?!
There is apparently a newly released actual fix that involves replacing the buttons... Check with your dealer to confirm
Will do!
