What did you do with your Grenadier today?

[Scott-Tx]

Fitted King shocks and stabiliser. Reason, I wanted to.
Don't want to start a debate
Though the biggest improvement this week was having drivers seat base firmed up and a lumbar support built into the seat back.
Anyone in the south want to try the mods you are most welcome.
To me its all very noticeable.
.

What did you torque the king front and rear shocks to?

 

[DaveB]

Happy and pissed off today with the grenadier.

Happy that ripping a tree stump (small but stubborn) out of the ground with my drag chain was a simple job with no fuss.

Pissed off because the tow hitch receiver is smaller than the standard Australian Hayman Reece type (that every single other manufacturer and third party seller uses in this country), so my recovery hitch doesn’t fit, not even close. So I had to use the retention pin to secure the soft shackle. I was ok with that because it wasn’t a tough job.

Come on Ineos - it’s not that bloody hard to use standard sized tow points for the various markets you sell to ffs.

So now off to my local 4wd accessories store to spend money on something I shouldn’t really have to.

Grrrrrr.
Anyway, 1st world problem.

I have seen conflicting information on if it is a 1 7/8 or 2"

 

[Clark Kent]

I used a Mr Hitches tow tongue as the hole on the supplied tounge was incorrect for my DO35, went in no problem.

Same. Specifically this one to get the correct rise to level out my hybrid camper.
I did need to shorten the shank and re-drill the pin holes due to the shallow Ineos receiver.