Are you asking if someone has installed a 4 wire trailer harness?
I'm assuming you did not get the factory hitch option?
The easiest (only?) way of doing this would be to get to the back of the taillights and piggyback off of those wires to trigger your 4 wire harness (assuming you've purchased a kit that just needs the triggers for each output). On the taillight the wire functions are labelled, so it should be pretty easy to see which wires you'll need
Installed CARROFIX Non-Powered Taillight Converter with 20" Inches Leads and 60" Inches 4-Wire Flat Extension Vehicle End Connector from Amazon. Remove Right rear trim panel. 6 bolts and trim clips. Wire harness is easy to get to.
Installed the 4 pin self closing cover down by hitch. Ran wires through thruhole in floor next to wire harness. 2 rubber grommets. One inside and one under car. Super easy.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.