- Local time
- 12:33 AM
- Joined
- Mar 1, 2023
- Messages
- 76
- Reaction score
- 192
- Location
- Los Angeles, California
I haven't opened the pack, it looks like its easy to mold around the ladder supports?
It is a bit stiffer than I thought even with the backer removed (which is ultimately a good thing) and I was installing in temps around 55 degrees F. So I used a heat gun to mold the material around the rungs and door sill contours. There is a fine line between too hot and too cold using the heat gun with this material, it's best to start on the "to cold" end and work up. Incidentally I found that when I had air bubbles trapped under the material I could hit the air bubble with a tad "too much" heat and the bubble would expand and the material would get really soft and the bubble would "pop" and then when removing the heat I would push on the spot with my finger and it would heal up nicely.
Thank you for the information
I wouldn't have any issues with making it palyable as ambient temp for me is 30c I do like the round edges, looks neat 
For that, after cutting the material to length, I just used a quarter-sized washer butted up to the corner and a pencil to create the contour and then trimmed with scissors prior to applicationThank you for the information
That's my camping setup now. A drawer kitchen and a drawer fridge. Chairs are the first thing accessible. My table is a real table, not one of these shaky, flimsy, small and low ones. Also easy acessible. It doubles as a sleeping platform. I can lower the left side of my box, put the table on top of the left folded rear seat and get a wonderful sleeping platform.
@Shopkeep, if you don't mind me asking, how is the hood secured to the console? Thank you!
Dimensions are tight so it just presses snugly over the top of the display and holds on. Some thin double sided tape on the top edge of the display may help reduce or prevent any movement and creaks but so far no issues.
More photos of your rear cargo set up please. Looks neat from what can be seen.Last weekend I installed sliding windows on both sides. These come from Explore Glazing in the Netherlands. Great quality, perfect fit and well made. If you follow the detailed instructions, assembly shouldn't be a problem for most people.
View attachment 7848608
The hardest part was cutting out the original window panes. There definitely have to be two of you and you need patience! ... not only the cutting wire burned out several times!
View attachment 7848609
I let it dry for 3 days without moving the Granadier. You shouldn't even close the doors.
View attachment 7848610
View attachment 7848611
ideal for my purposes. Great for the dogs, or for sleeping in the car!
View attachment 7848612
For the protective grille / Molle panel you have to drill the holes and cut the thread yourself. But shouldn't be a problem.
View attachment 7848613
View attachment 7848614
Your dog must be bloody athletic and have a good aim, to be able to jump into that crate
being a kelpie she good but not that good.
The box is self-made to maintain a flat surface with the rear seat folded down. On the right side there is space for 2 x 2 liter water bottles for the dogs, rain gear or similar fits under the lid.
That looks great! Is it really the same height with the folded seats? It looks much taller than I would have thought. That said, well done!
6 inch height to be flush with folded seats?
