Tremec gearbox cannot be switched

[User1]

View attachment 7837525
OK, it’s not very complicated to remove the shifter. You’ll need to pull the shaft and the spring out, compress them, put the pin back in and then reinstall the shifter. If it happens again, I might have to add a little bit of glue, but overall very easy fix

Can you describe how to remove the shifter?

 

[Hannes01]

If anyone finds the pin:
Please measure it and share the dimensions here.
The pin is not available separately - in Germany - the whole gearshift has to be replaced!

 

[Tinerfeño]

I did ask for pin dimensions 12 Nov, no reply yet.
It has to be some standard item.

 

[User1]

I will measure it tomorrow

I did ask for pin dimensions 12 Nov, no reply yet.
It has to be some standard item.

 

[Hannes01]

+ picture please

 

[DaBull]

+ picture please

Measurement with a micrometer please for diameter and length + photos.

 

[User1]

24x3mm

 

[DaBull]

24x3mmView attachment 7838129View attachment 7838130View attachment 7838128

Hi User1, Thanks for the measurements and photos. Is that a gouge, recess or keyway in the pin in photo 3?

 

[Tinerfeño]

That's a traditional way to make a small bulge to pin so that it jams into the hole. There should be 3 of those pressings.

 

[DaBull]

That's a traditional way to make a small bulge to pin so that it jams into the hole. There should be 3 of those pressings.

Seems to me if should have been a split pin that would have been a press in fit or perhaps some type of keeper to prevent it from falling out. Instead of a zip tie, would a small section of a tight rubber sleeve hold the pin in or would that interrupt with pulling up on the collar? DaBull

 

[RobS]

View attachment 7837525
OK, it’s not very complicated to remove the shifter. You’ll need to pull the shaft and the spring out, compress them, put the pin back in and then reinstall the shifter. If it happens again, I might have to add a little bit of glue, but overall very easy fix

My pin fell out today. How did you pull the lever and knob out?