Tow hitch receiver port too small

[Scotty8154]

I have a Class III 2" boat trailer hitch, jet ski trailer hitch and bike rack that I used with my former vehicle. None of them fit into the factory installed INEOS tow hitch receiver which is undersized by approximately approx. 1/32". The INOES tow hitch receiver port measure 2.010" x 2.036" (so at least it's over 2"), however, the trailer hitches and bike rack I have measure anywhere from 2.045" to 2.052". Anybody else have this issue?

 

[Tazzieman]

I have a Class III 2" boat trailer hitch, jet ski trailer hitch and bike rack that I used with my former vehicle. None of them fit into the factory installed INEOS tow hitch receiver which is undersized by approximately approx. 1/32". The INOES tow hitch receiver port measure 2.010" x 2.036" (so at least it's over 2"), however, the trailer hitches and bike rack I have measure anywhere from 2.045" to 2.052". Anybody else have this issue?

I had to buy the "USA 1" DO35 trailer hitch to fit my tow tongue, so I'm sure there's an Aussie product for you

 

[Rok_Dr]

Yes the Ineos receiver has quite tight tolerances so not all tongues fit. I've also found there is a bit of variation in tongue dimensions, even from reputable manufacturers as well. Also refer to the following thread.

https://www.theineosforum.com/threads/tow-hitch-dimensions.12414110/

Chewers
Steve