Tow hitch ball mount anti-rattle contraption?

[landmannnn]

European type approval 94/20/EC | NTTA

Towbars & European Type Approval 94/20/EC

www.ntta.co.uk

Looking in detail, what is published there is an extract from a pdf elsewhere on that site, it is dated 2000, so out of date.

 

[landmannnn]

So the European type approval reg’s don’t apply? All very confusing.

Even more confusingly, Witter sell a limited range of 2" receiver towbars, mostly for vans. They quote an EC type approval on their website.

So it must be that they are legal in the UK after all.

 

[Logsplitter]

Even more confusingly, Witter sell a limited range of 2" receiver towbars, mostly for vans. They quote an EC type approval on their website.

So it must be that they are legal in the UK after all.

I purchased my 2” receiver towbar direct from Ineos.

 

[Tom109]

This is what I use in my hitch extension.

Iron Grip Anti -Rattle Hitch Pin

 

[Hill Country TX]

I like the welded nut underneath, that's a good idea and had no idea it was there.

I've always sprayed my attachments with PlastiDip to create a nice soft protective layer while it's inside the receiver.

PlastiDip (Spray)

 

[grnamin]

Jesus! I hope it’s not m12!. I am away from my car for a few days so I can’t confirm.. i think it was 10…

The M10 titanium bolt I got was a bust. I forgot to account for thread pitch. Any idea what the thread pitch is? Cheers!

 

[Tom D]

It is just the standard m10x1.5 if you buy an m10 bolt at the hardware store that will be it.

 

[grnamin]

It is just the standard m10x1.5 if you buy an m10 bolt at the hardware store that will be it.

There lies my mistake. I ordered an m10x1.25. Cheers, Mate!

 

[Clark Kent]

To be clear: that welded nut is provided so you can install a bolt to stop the hitch from rattling when there is nothing connected to it. It should not be left tight when there is a towing load on the hitch. If you leave it tight the focused point load on the end of the bolt will at best damage the bolt or break the nut off, or at worst damage the lower face of the hitch (and especially if the bolt is harder than the hitch shank).
A loaded hitch won't rattle during towing due to down load but may clunk a bit when the hitch shifts minimally in the receiver due to pitching movements. That's normal.

Google 'towbar anti-rattle bolt'.

 

[Tazzieman]

I have one on the back of my vehicle and it doesn't rattle or move at all.
View attachment 7858098

Because it has an antirattle bolt, shifted with a 15mm spanner

 

[HereinDaRockies]

Well I'll be...
View attachment 7858075
Thank you, @Tom D!

god damn! I assume this has the 1.5mm thread pitch?