Show us your mods.

[BruceClaassen]

Simple ideas are often the best. I might steal your idea. What are you doing with the remaining 8 metres on the roll?

I had some clear ppf put over the raised door section between the 1st and 2nd rungs. It's cut out around the Lambda. I made a note to do this after seeing boot scratches on the doors of some of the test fleet that toured Australia.

Ha, I need to find an application for the rest of the roll! High on the list is to put two strips along 2 sides of the 'viewing platform' that I've put onto the roof to minimise slippages while sitting up there watching the world go by

PPF on the rear door is another good idea. The cuts around the Lambda look very precise - are you very good at wrapping or was it an aftermarket purchase (and if yes, where did you buy it?).

 

[Clark Kent]

Ha, I need to find an application for the rest of the roll! High on the list is to put two strips along 2 sides of the 'viewing platform' that I've put onto the roof to minimise slippages while sitting up there watching the world go by

PPF on the rear door is another good idea. The cuts around the Lambda look very precise - are you very good at wrapping or was it an aftermarket purchase (and if yes, where did you buy it?).

A few owners have put skateboard deck tape over the tread areas of their doorsills to add further protection over the vulnerable corners. A strip of anti-slip would do the same if you're looking for places to use it.

It's not my handiwork. My local sign shop does a lot of vinyl cut work and did the Lambda and clear ppf for not a lot of money. Far superior skills for the job. Coloured Lambda infills for Grenadier are available on Etsy and I think a US forum member was doing some sets a while back.