The Grenadier Forum
Register Now for enhanced site access.
INEOS Agents, Dealers or Commercial vendors please contact admin@theineosforum.com for a commercial account.

Raised air intake: what type of plastic?

grnamin

Grenadier Owner
Lifetime Supporter
Local time
4:34 PM
Joined
Oct 16, 2023
Messages
870
Reaction score
1,308
Location
Texas, USA
What type of plastic is the raised air intake made of? Mine was damaged going through a car wash. The tube cracked at the seam and I'm looking for an adhesive that can fuse the plastic together. Any ideas? Thank you.
 

trobex

Grenadier Owner
Local time
10:34 PM
Joined
Dec 23, 2022
Messages
1,902
Reaction score
2,443
Location
Australia
Many (most) plastic air intakes are ABS or LDPE. But please check with the dealer!!! In either case try the Permabond products of you can get it.
 

Quartermaster

Quatermaster Owner
Local time
11:34 PM
Joined
Dec 9, 2023
Messages
60
Reaction score
50
Location
Germany
It is made from polypropylene, which means bonding is not really possible, but welding.
 

trobex

Grenadier Owner
Local time
10:34 PM
Joined
Dec 23, 2022
Messages
1,902
Reaction score
2,443
Location
Australia
It is made from polypropylene, which means bonding is not really possible, but welding.
Is it actually Polyprop??? That is one of the crappiest materials to use for external plastics - weak, low flexural strength, prone to cracking, and even with modified additives it is crap in UV. Surely, they didn't make this intake from PP... then again, it's the cheapest plastic there is.
 

grnamin

Grenadier Owner
Lifetime Supporter
Local time
4:34 PM
Joined
Oct 16, 2023
Messages
870
Reaction score
1,308
Location
Texas, USA
I used Stick Fast cyanoacrylate. Seems to work. I'll keep the old adapter as a backup. Meanwhile, I purchased a new one from my dealer. Total cost: $46.68
1000006753.jpg
 

Quartermaster

Quatermaster Owner
Local time
11:34 PM
Joined
Dec 9, 2023
Messages
60
Reaction score
50
Location
Germany
Is it actually Polyprop??? That is one of the crappiest materials to use for external plastics - weak, low flexural strength, prone to cracking, and even with modified additives it is crap in UV. Surely, they didn't make this intake from PP... then again, it's the cheapest plastic there is.
Surely, they did. Otherwise i would not claim.
 

AngusMacG

Grenadier Owner
Lifetime Supporter
Local time
5:34 PM
Joined
Nov 6, 2023
Messages
776
Reaction score
1,134
Location
Massachusetts, USA
I started hearing a noise coming from the RAI area. Turned out it was separated a bit where it attaches on the quarter panel. A few clips broke and were replaced. All good so far.
 
Back
Top Bottom