Low Range Shift Cable Support Bracket

[JKAlpine]

I added the Low Range Shift Cable Support Bracket from Agile Offroad yesterday. I originally ordered after seeing how the factory zip-tied the cable to a wiring bundle. The zip tie is very thin and stiff, so my biggest concern over time was it cutting into the wire harness (I've seen zip ties cut into engine mounts on an airplane, believe it or not!). I always use GripLock Zipties (https://griplockties.com) to eliminate chafing and cutting, and I usually use a stand-off. The bracket is solid, and it's a tight fit. My only concern now is the cable rubbing the heatshield, but I would rather that than a wire harness.

Has anyone had any issues after installing the bracket?

 

[CountyV8]

We all use the genuine forum bracket

 

[CRH]

We all use the genuine forum bracket

Got mine ready to install

 

[JKAlpine]

We all use the genuine forum bracket

I've ordered that bracket too, but it's different. The forum bracket holds the push/pull cables in place, but the Agile bracket pushes it up over the shaft.

 

[CountyV8]

I've ordered that bracket too, but it's different. The forum bracket holds the push/pull cables in place, but the Agile bracket pushes it up over the shaft.

Which shaft?

 

[JKAlpine]

Which shaft?

Front drive shaft / flange

View: https://youtu.be/d34KtqplxXY?si=k6_ICSQfFWwVAOWd