Anyone seen the OEM drawer system in the configurator in person?

[CountyV8]

Ah I. looked on the configurator this morning and didn't see it will have to look again but im only a stones throw from Gearmate so may drop in .

 

[Mike Morrison]

View attachment 7887204

So the back seats don't lie completely flat to create a horizontal load platform or is this just an optical illusion?

 

[C'mon tae grips]

Front seats are pushed back and not sure if the Tougher seat covers also restricted them a bit. Will check later.

 

[bemax]

To fold them flat you have to pull up the seats forward, remove the head rests and than fold the back of the seat down.

 

[MRO]

Picture of my Gearmate twin drawer installed. Delighted with it. Fitted it on my own and very straightforward, bolted straight in. Perfect fit. Extremely well built. No rattles. Loadspace on top even easier to use than the OEM level. Also helps to reduce the booming from the poor rear acoustics. Sits a little higher than the rear seats when they are folded flat. Looks even better with the stickers taken off.

 

[LC0013]

Picture of my Gearmate twin drawer installed. Delighted with it. Fitted it on my own and very straightforward, bolted straight in. Perfect fit. Extremely well built. No rattles. Loadspace on top even easier to use than the OEM level. Also helps to reduce the booming from the poor rear acoustics. Sits a little higher than the rear seats when they are folded flat. Looks even better with the stickers taken off.

View attachment 7887279

On my list of items to purchase. Hopefully pretty soon.

 

[Roadking01]

Be nice if it had the tie down rails on top

 

[C'mon tae grips]

Be nice if it had the tie down rails on top

It does. It comes with four of these rings that slide in:

 

[Karearea]

Just wondering ….
How large is this when it ships?
Any chance that it will arrive intact down under
Edit, ignore the Austrian flag as I’m with my sons ski racing!

 

[artschool]

It does. It comes with four of these rings that slide in:
View attachment 7887674

that's not the OEM version that the one from gearmate direct.

 

[TexasCrane]

It arrived this morning (very well packaged) and installed it over lunchtime. Let me know if you want any more photos:
View attachment 7887195

Their website says 10 minute install/remove. Is it really that fast?

 

[C'mon tae grips]

Their website says 10 minute install/remove. Is it really that fast?

First time installing it takes longer, as you have to take out the tie-down rails (Trialmaster) and install the brackets. Theoretically, it could be done in 10 as all you have to do is take the drawer out, remove two screws and it should just lift out and then reverse to install it. I'd probably first take off the infill panels, which would add some time. A second pair of hands also makes it much easier.