The Grenadier Forum
Register Now for enhanced site access.
INEOS Agents, Dealers or Commercial vendors please contact admin@theineosforum.com for a commercial account.

Rust

JohnHeagney

Grenadier Owner
Lifetime Supporter
Local time
4:28 PM
Joined
Oct 12, 2022
Messages
313
Reaction score
844
Location
Carlton-in-Cleveland, Middlesbrough, UK
Hi All

Does anyone elae have Rust on the wheel nuts, locking nut and side bars? These photos are of each wheel and two of each of the side rails.

Maybe the salt used on the North Yorkshire roads doesn't help but this isn't good, I have done just less than 16,000 miles in 53 weeks.

My dealer say (always found them very good) that this is not a general problem and that they are awaiting a response from Ineos Automotive - and have been for quite a few weeks.....

Thanks
Rust 5.jpg
Rust 6.jpg
Rust 7.jpg
Rust 8.jpg
Rust 1.jpg
Rust 2.jpg
Rust 3.jpg
Rust 4.jpg


John
 

rovie

Grenadier Owner
Lifetime Supporter
Local time
11:28 AM
Joined
May 19, 2022
Messages
2,128
Reaction score
3,999
Hi All

Does anyone elae have Rust on the wheel nuts, locking nut and side bars? These photos are of each wheel and two of each of the side rails.

Maybe the salt used on the North Yorkshire roads doesn't help but this isn't good, I have done just less than 16,000 miles in 53 weeks.

My dealer say (always found them very good) that this is not a general problem and that they are awaiting a response from Ineos Automotive - and have been for quite a few weeks.....

ThanksView attachment 7856181View attachment 7856182View attachment 7856183View attachment 7856184View attachment 7856194View attachment 7856195View attachment 7856196View attachment 7856197

John
Hi John,
in my view, this is absolutely unacceptable. So far, I have not had any rust spots like this. However, I didn't drive in salt last winter either.
I often drive in mud on my fields and the dirt settles on the door sills. As I don't always have time to wash it off, the moisture stays on the surface for longer. I will observe this and report back.
I'm interested to hear what your dealer and Ineos have to say and how they react.
 

rovie

Grenadier Owner
Lifetime Supporter
Local time
11:28 AM
Joined
May 19, 2022
Messages
2,128
Reaction score
3,999
I have rust on the hub edges of the steel wheels. Dealer made "note" of it.
Yes, I have that too. But that doesn't worry me. This is also the case with other vehicles, but you can't see it at first glance because of the hubcaps.
 

AMD66

Grenadier Owner
Lifetime Supporter
Local time
4:28 PM
Joined
Oct 15, 2023
Messages
131
Reaction score
442
Location
UK
I’ve done 8,500 miles on Northumberland & Scotish Borders heavily salted roads and have nothing on wheel nuts. I have a few rust spots on side steps , yours seem heavily pitted and rusted in comparison.
 
Local time
11:28 AM
Joined
Sep 13, 2023
Messages
359
Reaction score
448
Location
Michigan, USA
Bad plating on the nuts. Replace, as Alloy wheels deserve proper nuts.

Sand abrasion on the bars.
More than likely, the bars will need regular attention with tractor paint (epoxy hardener added)
This has been cited here previously by an Aussie member after a longish desert trip.

I do an annual on my mowers because my sandy soil wears off the coatings. Tractor paint lasts a good long time and is easy to apply every spring. A can of flat black epoxy and a cardboard shield for over spray.

I do the same on my Mule and my Gator, because once their paper thin frame goes due to rust, they are finished.
We can argue about the coating specification for the bars, but that would be of little help.

On my Mule the dealer popped the bars off, cleaned them, and sprayed them w/tractor paint, and I've had no wear through since.
Yet, the original coating on the bars wore off within 1 week of purchase. And they said it was my fault!
I'm guessing the powdercoat on the bars is very thin to start.
 

Logsplitter

Photo Contest Winner
Grenadier Owner
Lifetime Supporter
Local time
4:28 PM
Joined
Oct 31, 2022
Messages
2,817
Reaction score
10,078
Location
🇬🇧
My side steps are rusty but have had a hard life on dirt and gravel roads. When I get the vehicle back I will remove them, clean them and use rust converter. I will probably treat all underneath with Lanoguard in the summer also. No rust on wheel nets that I’m aware of
IMG_1757.jpeg
IMG_1758.jpeg
 

Shaky

Grenadier Owner
Forum Donor
Local time
11:28 AM
Joined
Apr 28, 2022
Messages
1,495
Reaction score
3,140
Look up a company website called Bilt Hamber, despite the name sounding possibly German (nothing wrong with that), they are a British company.

They are well known for car cleaning products and also rust inhibitors for vehicles. They do one for inside chassis’s and one for everything. Else under a vehicle, I am going to do all of mine in this stuff.

Like others say your steps look a lot worse than many others, but the OEM steps seem to have a rattle can paint finish from China, the dealer/IA might say replace but will you have the same in 12 months time ?? Or you could just bite the bullet, sand them, rust treat them and put some tractor paint on them and then double down with a Bilt Hamber treatment….belt and braces.
 

shiv.nandak

Grenadier Owner
Local time
11:28 AM
Joined
May 31, 2023
Messages
224
Reaction score
216
Location
Pittsburgh, PA, USA
My side steps are rusty but have had a hard life on dirt and gravel roads. When I get the vehicle back I will remove them, clean them and use rust converter. I will probably treat all underneath with Lanoguard in the summer also. No rust on wheel nets that I’m aware of View attachment 7856263View attachment 7856264
How is your fuel tank bash plate? I'm willing to bet that it's completely rusted too.
 
  • Like
Reactions: PBD

SkiBum1

GG-4567
Grenadier Owner
Lifetime Supporter
Local time
10:28 AM
Joined
Nov 20, 2023
Messages
213
Reaction score
484
Location
Chicago, IL, USA
Hi All

Does anyone elae have Rust on the wheel nuts, locking nut and side bars? These photos are of each wheel and two of each of the side rails.

Maybe the salt used on the North Yorkshire roads doesn't help but this isn't good, I have done just less than 16,000 miles in 53 weeks.

My dealer say (always found them very good) that this is not a general problem and that they are awaiting a response from Ineos Automotive - and have been for quite a few weeks.....

ThanksView attachment 7856181View attachment 7856182View attachment 7856183View attachment 7856184View attachment 7856194View attachment 7856195View attachment 7856196View attachment 7856197

John
I am sure all of this is covered under the warranty. The rock sliders rusting is clearly an inadequate powder coating manufacturer defect.
 

TheDocAUS

Grenadier Owner
Lifetime Supporter
Local time
3:28 AM
Joined
Mar 8, 2023
Messages
2,402
Reaction score
4,203
Location
Eromanga
I am sure all of this is covered under the warranty. The rock sliders rusting is clearly an inadequate powder coating manufacturer defect.
Cheap Chinese steel and poor powder coating. I had rock sliders on my Patrol for years in harsh Outback conditions and they still looked way better than that INEOS mistake.
 

trobex

Grenadier Owner
Local time
4:28 PM
Joined
Dec 23, 2022
Messages
1,824
Reaction score
2,399
Location
Australia
I had a 18 year old work ute up until recently with less rust around any wheel component or fixing than you vehicle is showing which is effectively brand new... lodge a warranty claim. The wheel nuts are very poor in your example... HDG I think not.
 

Tom D

Grenadier Owner
Lifetime Supporter
Local time
4:28 PM
Joined
Jun 3, 2022
Messages
991
Reaction score
2,738
Location
Berwickshire
In the UK with all the salt on the roads powder coating doesn't stand a chance, even the good stuff won't last, especially in a high impact area. Hence I was happy to pay the extra for the Buzz stainless sliders. What I'd do is take them off, and drop them at your local agricultural fabricators, they can send them off with their next consignment to be hot dip galvanised. You could then paint them with raptor black or similar. Or just get the buzz ones....
 

G-Man

Grenadier Owner
Local time
4:28 PM
Joined
May 19, 2022
Messages
312
Reaction score
622
Location
Aberdeen, Scotland
Does anyone else have rusting Torx retaining screws in the utility strips/snorkel mounting points on the outside of the vehicle? I think they've a Japaned coating but mine were showing spots of rust straight off the showroom floor, not a great look for a brand new vehicle! I guess they're shipped by sea and the salt air would find any bare metal within a few hours.

Has anyone swapped them for stainless screws yet? If so what spec/length did you go for?
 
Back
Top Bottom