Mine did not come with instructions but was very straightforward. if you're doing it at home, you need a 3/16 drill bit and a Pop Rivet Tool ($24 at Lowes).
I would reach out to dealers where parts are an option. Some are willing to ship internationally, but it can get expensive.
Can you post amain link to the page that has other directions? Thank you.
Or use monel rivets if there is steel involved anywhere. They are very hard rivets but used a lot on boats where al/fe are close together
I should be all alloy.Or use monel rivets if there is steel involved anywhere. They are very hard rivets but used a lot on boats where al/fe are close together
They are offered stateside. Picked mine up yesterday with dealer installed checker plates
Yup, my dealer actually had a set available in the parts department. I'm installing them with 3M VHB tape only. No drilling. 1/4" wide roll available on amazon.
Yes black rivets please or perhaps no drill and use 3M VHB tape like @Jeffrey
![[ Adam ]](https://ineosforum-data.community.forum/avatars/s/9046/9046040.jpg?1705937698){kind=avatar}
