My screen has gone blank, multiple lights and alarms sounding.
2024 trialmaster with aux battery system; 4670 miles; 4 hours from dealer; no software update; no problems with grenadier until this.
Four days ago we had a light rain. That afternoon I got into the car and noticed some wetness in the overhead liner (Picture 1 - damp overhead liner).
I also saw some drips from the overhead (Picture 2- water droplets).
I dried the area and inspected the roof and saw no issues. Yesterday, I drove the Grenadier and a few minutes into the drive, I noticed that the right side of the infotainment screen changed color, then the same side of the screen began to flash between black and this purple color (Picture 3-purple info screen).
I decided to head back given the issue and within about 5 minutes, the entire screen went fully blank and stayed that way, and multiple telltale lights came on, beeps started, and the turn signals were only functioning intermittently (Photo 4 - telltale while driving)
I looked on the forum and, in the manual for any ideas. I tried the mute button reset (30-sec hold) and it did nothing. I tried disconnecting the battery per the manual's instructions (disconnect ground from battery connector, negative from auxiliary battery, then negative from primary battery). I waited 10 minutes, then reconnected all in reverse order. Waited another 10 minutes. Turned key to activate the battery and multiple alarms still showing and lights flashing including locker lights, lights behind vent and hvac controls knob, and interior lighting. Started vehicle, and had continued multiple telltale alerts, constant seatbelt chiming, lights flashing. I shut down grenadier and waited overnight. Today, a half start showed multiple [but different] telltale lights and no screen - entirely black, no gauges, speed, etc. - (Photo 5 - half start telltale).
View attachment IMG_0306.jpg
I started the grenadier and got similar lights and more on the telltale. The seatbelt alarm was also constantly alarming. The lights that were flashing yesterday we no longer flashing (Photo 6 - full start).
I shut off the grenadier and took the key out, and locked the door, the seatbelt chime was still alarming inside. I reinserted the key, turned halfway, and then turned back off and seatbelt chime stopped.
UPDATE 30OCT24
The day of the original post, the Grenadier alarm started going off in the middle of the night for about 4 minutes, then shut off on its own. The next morning, I tried to start the Grenadier, and there was no electrical power and therefore would not start.
After a call to the dealer, and thanks to other forum suggestions, I scheduled a tow with INEOS Roadside Assistance (+1-866-882-6411). Nearest dealer (RTGT Ineos, Wilsonville Oregon) is 183 miles from me. Ineos roadside assistance covers the first 100 miles. For the other 83 miles, I paid US$784.00.
When the tow truck arrived today, a new set of issues emerged.
The car has no electrical, so no way to shift into Neutral to be put on a flatbed tow truck. I called the dealer who suggested to jump start the battery in order to have power and shift into neutral. I followed the owner's manual instructions to jump start the battery. This did not work, no power was on in the vehicle, and there was no ability to start the vehicle or shift into Neutral.
I called the dealer again and mentioned that the owner's manual has another method listed to place the vehicle in Neutral (turning bolt underneath vehicle [the tool needed is in the included vehicle tool kit]). The dealer mentioned that they had not faced this before. They nicely had one of their techs take a picture under a grenadier showing the location of the bolt and texted this to me. Simultaneously I reviewed any online information about this issue and all posts on this forum with potential information on this. I reviewed the following Forum posts:
Procedure to shift into Neutral with a dead battery (fiddly but doable) | The Grenadier Forum (theineosforum.com)
Had to have vehicle towed today - editing title - found out not Ineos' fault! | The Grenadier Forum (theineosforum.com)
Grenadier won't move after engaging/disengaging neutral bolt | The Grenadier Forum (theineosforum.com)
Neutral bolt, help needed | The Grenadier Forum (theineosforum.com)
panne démarrage (Startup failure) | The Grenadier Forum (theineosforum.com)
The dealer said to turn the bolt clockwise until it "bottomed out." The owner's manual said to move the transfer case lever to a position between HIGH/LOW before turning the bolt. Forum posts varied on the transfer case movement and the pictures of service manuals on some forum posts did not match my service manual; I downloaded the service manual from the Ineos website and this version also did not match my manual. I decided to follow what my manual (included with the vehicle) said.
I tried to move the transfer case into a position between HIGH/LOW. There was some slight movement downwards. Whether or not this was fully accomplished is unknown because there is no electronic display to confirm. There was no feeling, locking, clunking, or other input to my hand that made it feel like anything had moved or shifted into another setting. I then used the tool to turn the bolt clockwise (there is a small arrow beside the bolt that indicates to turn clockwise). I turned the bolt until it became difficult and eventually was unable to turn any further. The tow truck driver confirmed and was also unable to turn further. This should have manually put the vehicle into Neutral. I lowered the parking brake, turned the key halfway (as indicated in manual), closed the door and the car would not move and was not in Neutral. I tried again with the key in the ignition, but not halfway turned. I tried again with the key out of the ignition. The doors were firmly shut. Again, no movement. Note that the steering wheel was also unlocked this entire time.
I called the dealer who "haven't heard or seen this before" and let them know that none of the methods had worked. They had no additional suggestions and told me to work with the tow company to get it to them.
I then reversed the procedure - I followed the manual instructions to place the bolt back into the original position (bolt flush with case). After turning counterclockwise for some number of turns, the bolt felt flush with the face, the bolt looked flush with the face, and the bolt was unable to turn any further (also confirmed by tow truck driver). The shifter was moved back to the HIGH setting (again only a small bit of movement upwards) where it was originally. Whether or not this was fully accomplished is unknown because there is no electronic display to confirm. There was no feeling, locking, clunking, or other input to my hand that made it feel like anything had moved or shifted into another setting. According to the manual and my process, the vehicle was now back in its original state. As a check, we could not move the vehicle at this point either.
By now (2.5 hours from start), the tow truck driver had called his supervisor who had also showed up. Both of their suggestions were to slide the vehicle a few feet onto the truck using their chains/winch. The Grenadier was sitting on concrete. Obviously, the wheels were not rolling freely and this vehicle is quite heavy. I expressed my reticence at just dragging it onto the truck but was told by the towing crew that since it had to travel so far and go through some serious mountain passes, that having it on the flatbed was the best option. They proceeded to put some lubricant onto the ground behind the wheels and some lubricant on the truck bed. They then used the winch and hauled it up onto the truck and secured it.
I did not like watching the Grenadier scrape across the driveway and try to resist being pulled onto the truck.
The Grenadier is now in route to the dealer for assessment. I will cross-post a link to this post on all of the forum posts I reviewed for help in case other people end up in the same position. I will continue to update this post as the situation changes.
2024 trialmaster with aux battery system; 4670 miles; 4 hours from dealer; no software update; no problems with grenadier until this.
Four days ago we had a light rain. That afternoon I got into the car and noticed some wetness in the overhead liner (Picture 1 - damp overhead liner).
I also saw some drips from the overhead (Picture 2- water droplets).
I dried the area and inspected the roof and saw no issues. Yesterday, I drove the Grenadier and a few minutes into the drive, I noticed that the right side of the infotainment screen changed color, then the same side of the screen began to flash between black and this purple color (Picture 3-purple info screen).
I decided to head back given the issue and within about 5 minutes, the entire screen went fully blank and stayed that way, and multiple telltale lights came on, beeps started, and the turn signals were only functioning intermittently (Photo 4 - telltale while driving)
I looked on the forum and, in the manual for any ideas. I tried the mute button reset (30-sec hold) and it did nothing. I tried disconnecting the battery per the manual's instructions (disconnect ground from battery connector, negative from auxiliary battery, then negative from primary battery). I waited 10 minutes, then reconnected all in reverse order. Waited another 10 minutes. Turned key to activate the battery and multiple alarms still showing and lights flashing including locker lights, lights behind vent and hvac controls knob, and interior lighting. Started vehicle, and had continued multiple telltale alerts, constant seatbelt chiming, lights flashing. I shut down grenadier and waited overnight. Today, a half start showed multiple [but different] telltale lights and no screen - entirely black, no gauges, speed, etc. - (Photo 5 - half start telltale).
View attachment IMG_0306.jpg
I started the grenadier and got similar lights and more on the telltale. The seatbelt alarm was also constantly alarming. The lights that were flashing yesterday we no longer flashing (Photo 6 - full start).
I shut off the grenadier and took the key out, and locked the door, the seatbelt chime was still alarming inside. I reinserted the key, turned halfway, and then turned back off and seatbelt chime stopped.
UPDATE 30OCT24
The day of the original post, the Grenadier alarm started going off in the middle of the night for about 4 minutes, then shut off on its own. The next morning, I tried to start the Grenadier, and there was no electrical power and therefore would not start.
After a call to the dealer, and thanks to other forum suggestions, I scheduled a tow with INEOS Roadside Assistance (+1-866-882-6411). Nearest dealer (RTGT Ineos, Wilsonville Oregon) is 183 miles from me. Ineos roadside assistance covers the first 100 miles. For the other 83 miles, I paid US$784.00.
When the tow truck arrived today, a new set of issues emerged.
The car has no electrical, so no way to shift into Neutral to be put on a flatbed tow truck. I called the dealer who suggested to jump start the battery in order to have power and shift into neutral. I followed the owner's manual instructions to jump start the battery. This did not work, no power was on in the vehicle, and there was no ability to start the vehicle or shift into Neutral.
I called the dealer again and mentioned that the owner's manual has another method listed to place the vehicle in Neutral (turning bolt underneath vehicle [the tool needed is in the included vehicle tool kit]). The dealer mentioned that they had not faced this before. They nicely had one of their techs take a picture under a grenadier showing the location of the bolt and texted this to me. Simultaneously I reviewed any online information about this issue and all posts on this forum with potential information on this. I reviewed the following Forum posts:
Procedure to shift into Neutral with a dead battery (fiddly but doable) | The Grenadier Forum (theineosforum.com)
Had to have vehicle towed today - editing title - found out not Ineos' fault! | The Grenadier Forum (theineosforum.com)
Grenadier won't move after engaging/disengaging neutral bolt | The Grenadier Forum (theineosforum.com)
Neutral bolt, help needed | The Grenadier Forum (theineosforum.com)
panne démarrage (Startup failure) | The Grenadier Forum (theineosforum.com)
The dealer said to turn the bolt clockwise until it "bottomed out." The owner's manual said to move the transfer case lever to a position between HIGH/LOW before turning the bolt. Forum posts varied on the transfer case movement and the pictures of service manuals on some forum posts did not match my service manual; I downloaded the service manual from the Ineos website and this version also did not match my manual. I decided to follow what my manual (included with the vehicle) said.
I tried to move the transfer case into a position between HIGH/LOW. There was some slight movement downwards. Whether or not this was fully accomplished is unknown because there is no electronic display to confirm. There was no feeling, locking, clunking, or other input to my hand that made it feel like anything had moved or shifted into another setting. I then used the tool to turn the bolt clockwise (there is a small arrow beside the bolt that indicates to turn clockwise). I turned the bolt until it became difficult and eventually was unable to turn any further. The tow truck driver confirmed and was also unable to turn further. This should have manually put the vehicle into Neutral. I lowered the parking brake, turned the key halfway (as indicated in manual), closed the door and the car would not move and was not in Neutral. I tried again with the key in the ignition, but not halfway turned. I tried again with the key out of the ignition. The doors were firmly shut. Again, no movement. Note that the steering wheel was also unlocked this entire time.
I called the dealer who "haven't heard or seen this before" and let them know that none of the methods had worked. They had no additional suggestions and told me to work with the tow company to get it to them.
I then reversed the procedure - I followed the manual instructions to place the bolt back into the original position (bolt flush with case). After turning counterclockwise for some number of turns, the bolt felt flush with the face, the bolt looked flush with the face, and the bolt was unable to turn any further (also confirmed by tow truck driver). The shifter was moved back to the HIGH setting (again only a small bit of movement upwards) where it was originally. Whether or not this was fully accomplished is unknown because there is no electronic display to confirm. There was no feeling, locking, clunking, or other input to my hand that made it feel like anything had moved or shifted into another setting. According to the manual and my process, the vehicle was now back in its original state. As a check, we could not move the vehicle at this point either.
By now (2.5 hours from start), the tow truck driver had called his supervisor who had also showed up. Both of their suggestions were to slide the vehicle a few feet onto the truck using their chains/winch. The Grenadier was sitting on concrete. Obviously, the wheels were not rolling freely and this vehicle is quite heavy. I expressed my reticence at just dragging it onto the truck but was told by the towing crew that since it had to travel so far and go through some serious mountain passes, that having it on the flatbed was the best option. They proceeded to put some lubricant onto the ground behind the wheels and some lubricant on the truck bed. They then used the winch and hauled it up onto the truck and secured it.
I did not like watching the Grenadier scrape across the driveway and try to resist being pulled onto the truck.
The Grenadier is now in route to the dealer for assessment. I will cross-post a link to this post on all of the forum posts I reviewed for help in case other people end up in the same position. I will continue to update this post as the situation changes.
Last edited:
