The Grenadier Forum
Register Now for enhanced site access.
INEOS Agents, Dealers or Commercial vendors please contact admin@theineosforum.com for a commercial account.

Coil spring air suspension

dime80

Grenadier Owner
Local time
5:31 PM
Joined
Oct 1, 2022
Messages
63
Reaction score
146
Location
Sunshine Coast
Great. That’s the same as I’ve ordered
How are they when empty and alternately when full loaded. What pressures are you using.
With 260kg tow ball weight running 45psi. Rides with a lot more confidence, and level with van. When empty I leave about 20psi to keep shape. have Engle fridge, double draws and kelpie in the back
 

Tazzieman

Grenadier Owner
Lifetime Supporter
Founding Guard
Local time
5:31 PM
Joined
Sep 30, 2021
Messages
6,584
Reaction score
13,140
Location
Tasmania
With 260kg tow ball weight running 45psi. Rides with a lot more confidence, and level with van. When empty I leave about 20psi to keep shape. have Engle fridge, double draws and kelpie in the back
I'm at 230/40/15psi
 

Tazzieman

Grenadier Owner
Lifetime Supporter
Founding Guard
Local time
5:31 PM
Joined
Sep 30, 2021
Messages
6,584
Reaction score
13,140
Location
Tasmania
Hi Tazzieman
Where did you get the air valves fitted. I am fitting the airbags myself. Thanks in advance
Just below the rear bumper
1000025656.jpg
 

DMarchand

Grenadier Owner
Local time
2:31 AM
Joined
Oct 24, 2023
Messages
35
Reaction score
35
Location
Hampton, NH, USA
@GrenX to get the valves to that location what level of disassembly is needed? The whole rear bumper off?

Thanks,
Steve
I'm not GrenX but I installed mine. Simple answer is no, you can reach that location either by pushing the bumper material (plastic) down or from behind in the wheel well. No disassembly required.
 

GrenX

Grenadier Owner
Supporting Vendor
Local time
5:31 PM
Joined
Sep 7, 2023
Messages
94
Reaction score
448
Location
Melbourne VIC, Australia
@GrenX to get the valves to that location what level of disassembly is needed? The whole rear bumper off?

Thanks,
Steve
I'm not GrenX but I installed mine. Simple answer is no, you can reach that location either by pushing the bumper material (plastic) down or from behind in the wheel well. No disassembly required.
This is correct you don't need to remove the bar to fit the valves, its easy and protected location from mud and dust. We have fitted some for clients where the petrol filler is but its more complicated install so I prefer the bar location.
 
Back
Top Bottom