Australasia Any info on disassembling the shinny black trim above the glove box

[Roger]

I am trying to disassemble/remove the trim around the glove box (RHD).
I have been pulling on the black narrow trim and some sections have released OK but some are very stubborn and I don't want to break it.
I am trying to remove this trim on BOTH sides of the grab handle.
Any images or workshop manual info would be a great help.
The Pic below I lifted one of MACS posts on this forum (Thanks!) I have cropped it

and added some arrows.

 

[Jean Mercier]

I am trying to disassemble/remove the trim around the glove box (RHD).
I have been pulling on the black narrow trim and some sections have released OK but some are very stubborn and I don't want to break it.
I am trying to remove this trim on BOTH sides of the grab handle.
Any images or workshop manual info would be a great help.
The Pic below I lifted one of MACS posts on this forum (Thanks!) I have cropped it View attachment 7840370and added some arrows.

Didn't do it yet completely, but yes partially.

You should start with some smaller ones, those are clipped.
Some of the longer ones have screws.

See my post here:

Has anyone successfully removed the Centre console panel?

And how did you get out the cup holder? It still sits tight when the four little screws are taken out. Is it fixed with additional clips? Yes clips, if you go to posts #18 and #20 of @rovie you see the explanation.

www.theineosforum.com