Adding L-track rails for exterior doors?

[Todd]

Has anyone found a supplier for L-track rails for the doors? I have found a lot of options, but unsure what would look most stock? I have the bumpers currently.

Or does anyone know what dimensions would fit?
I found these that look promising...

Thanks!

 

[TheDocAUS]

There is a thread on after market fitting of tracks. I will try and find it.

L tracks and tie down rings generally is here. Also this thread here.

 

[Todd]

There is a thread on after market fitting of tracks. I will try and find it.

L tracks and tie down rings generally is here. Also this thread here.

I appreciate your help but both of those are about the attachments as far as I can tell. I am looking for help for the rails themselves.

 

[TheDocAUS]

I appreciate your help but both of those are about the attachments as far as I can tell. I am looking for help for the rails themselves.

There is another thread, which I cannot locate. Maybe you can.

 

[TheDocAUS]

There are two suppliers of aftermarket L track noted in this post. You will need to find the US agents.

 

[Todd]

There are two suppliers of aftermarket L track noted in this post. You will need to find the US agents.

ok. Thank you for your help

 

[bamanuke]

Has anyone found a supplier for L-track rails for the doors? I have found a lot of options, but unsure what would look most stock? I have the bumpers currently.

Or does anyone know what dimensions would fit?
I found these that look promising...

Thanks!

View attachment 7883798 View attachment 7883799

check with the dealer. I ordered the ones for the rear quarter panels with hardware and it was less than $200.00. (and all the holes line up)

 

[pmatusov]

You need undrilled 1" (25mm)-wide L-track. The Grenadier L-track mounting hole spacing is on a 2" spacing grid, but neither 4" nor 6" nor regular.

 

[Jeffrey]

The VanEssentials 1" wide rectangular cross section L-track fits in the channel just fine, but you need to be able to precisely measure and drill/countersink new holes to match the threaded holes on the vehicle. I cut from both ends to be able to use one or two of the VE provided holes and added the remaining ones myself. Not hard for me since I'm a machinist and have my own shop (not to mention over 50 years of metalworking experience). If this is not your comfort zone, then take your vehicle and the L-track to a local machinist and have them measure and cut it for you.