BonjourBonjour,
J'ai réalisé un tuto sur le raccordement des sorties électriques aux pieds du conducteur et du passager. Ces sorties sont commandées respectivement par les interrupteurs INT1 et INT2 au tableau électrique supérieur. Le tuto précise comment avoir accès aux fils et proposer un emplacement pour les nourrices 12 Volts et USB A.
Le lien sur mon Drive Google
20231004_Tuto Raccordement des prises INT1 et INT2.pdf
drive.google.com
J'ai mesuré la tension de la batterie principale (12,6 Volts) et secondaire (12,9 Volts).
Les sorties commandées par INT1 et INT2 sont reliées à la batterie principale. Il faut donc éviter d'y brancher un équipement trop gourmant (max 10 A sur chaque sortie) et surtout de laisser en fonctionnement la nuit au bivouac sous peine de ne pas démarrer le lendemain.
Il me semblerait judicieux de pouvoir alimenter les sorties INT1 et INT2 par la batterie secondaire.
Nourrice sur INT2 (côté passager)
View attachment 7828709
Nourrice 12 Volts et deux USB A sur INT1 Pieds conducteurs
View attachment 7828710
search "Canny outdoors" on YouTube. John Canny, a member on this forum has an excellent video where he prepares his Grenadier for outback travel.. including uncovering and connecting the aux. outlets.
Here is the Canny Outdoors video on locating the footwell outlets (mentioned by @DenisM).
When trying to locate the wire ends in all 3 locations, look for a small amount of black electrical tape around black fabric tape used on the loom. That is the easiest way to home into the precise location, once you know the general areas too look. That black electrical tape is what is taping the wire ends to the black fabric tape of the loom.
Would this location be on the left hand side for an American Car? Or would it always be located on the right hand side? Thank you for your videos.
Short answer yes. There will be wire ends in the passenger and driver side footwells. These wire ends are taped to the wiring loom and sometimes can be hard to find. Look for plastic tape around the loom's fabric tape, because often that plastic tape is holding the wire ends to the loom (this was the case with my car).
Yes there are, they are standard on ALL models irrespective of high power aux power option. I have single battery and no aux option but have footwell and 10amp under bonnet outlet
Thanks, you are correct, the footwell wire ends are part of the Standard power option. I will correct my earlier post and reference the Rok Dr Guide.
All UK models have them. On Aus models what do the overhead switches Power, and the other 3 do?? if no footwell outlets?
Unfortunately F128 is for the entire overhead panel. F128 does not switch on and off with EXT1 only. I am hoping to find EXT1 switched power somewhere in the passenger compartment. And not in the engine bay.
