Wind noise from the full size Rhino Rack is a bit much. I build this out of a piece of 14x60" 1/4" ABS sheet. Center cut is 1.75 deep and 10.5 wide. Lower bend is 1.75" up from the bottom, and top bend is 3" from the top. I 3D printed some T nuts and bolted it down. The top bend is a bit more bent than it has to be so it is "Sprung" against the rubber seal around the windshield (though I need to bend the outer corners a bit more).
The net is that it works. Wind noise from the rack is way less and totally livable. I may experiment with other shapes and see if anything is better, but this works pretty well.
The net is that it works. Wind noise from the rack is way less and totally livable. I may experiment with other shapes and see if anything is better, but this works pretty well.
