What's new
The Grenadier Forum
Register Now for enhanced site access.
INEOS Agents, Dealers or Commercial vendors please contact admin@theineosforum.com for a commercial account.

Tremec gearbox cannot be switched

User1

User1

Grenadier Owner
Local time
2:46 PM
Joined
May 30, 2022
Messages
9
Reaction score
14
Location
Germany
Terrain Traveler said:
View attachment 7837525
OK, it’s not very complicated to remove the shifter. You’ll need to pull the shaft and the spring out, compress them, put the pin back in and then reinstall the shifter. If it happens again, I might have to add a little bit of glue, but overall very easy fix
Click to expand...

Can you describe how to remove the shifter?
 
Hannes01

Hannes01

Grenadier Owner
Lifetime Supporter
Local time
2:46 PM
Joined
Jan 19, 2023
Messages
667
Reaction score
1,145
Location
Germany
If anyone finds the pin:
Please measure it and share the dimensions here.
The pin is not available separately - in Germany - the whole gearshift has to be replaced!
 
User1

User1

Grenadier Owner
Local time
2:46 PM
Joined
May 30, 2022
Messages
9
Reaction score
14
Location
Germany
24x3mm
1000017584.jpg
1000017583.jpg
1000017587.jpg
 
DaBull

DaBull

Grenadier Owner
Lifetime Supporter
Local time
5:46 AM
Joined
Dec 28, 2022
Messages
1,410
Reaction score
2,695
Location
California
Tinerfeño said:
That's a traditional way to make a small bulge to pin so that it jams into the hole. There should be 3 of those pressings.
Click to expand...
Seems to me if should have been a split pin that would have been a press in fit or perhaps some type of keeper to prevent it from falling out. Instead of a zip tie, would a small section of a tight rubber sleeve hold the pin in or would that interrupt with pulling up on the collar? DaBull
 
RobS

RobS

Grenadier Owner
Local time
8:46 AM
Joined
May 15, 2023
Messages
393
Reaction score
503
Location
USA - New Jersey
Terrain Traveler said:
View attachment 7837525
OK, it’s not very complicated to remove the shifter. You’ll need to pull the shaft and the spring out, compress them, put the pin back in and then reinstall the shifter. If it happens again, I might have to add a little bit of glue, but overall very easy fix
Click to expand...
My pin fell out today. How did you pull the lever and knob out?
 
You must log in or register to reply here.
Forum Store
The officially unofficial podcast for INEOS Automotive Grenadier Works Podcast
INEOS Grenadier Configurator

Latest posts

Share this page

Back
Top Bottom