They are Denali D3's with the Denali automotive wiring harness.
one of the dealers on the various FB groups posted that they take a feed for any dashcams from either one of the roof panel switches Labelled Int. 1 & 2. These are wired to switch the footwell power outlets and really close to where you want the camera and leave no bloody wires trailing across the dashboard from the internal USB ports.
me too. very interested in these and fittings
Behind the plastic inner front wing on drivers side RHD vehicle is an unused factory grommet in the firewall, possibly for winch control
The dash cam has a feed directly to the aux battery so that the cameras work in parking mode. routed up the pillar under roof lining and out by the rear view mirror then the return to rear of the roof down the rear pillar and in the big door.
(any night shots )
I prefer than that way on short range to light up the verges on our narrow country roads.
They look nice
There is not a lot of room between the bash plate and rad. The wiring harness came from the fog light makers.They look nice
How was the wiring and space around that area to do some DYI?
Pulled loads off the car today and can't find a "spare" gromet anywhere! Oh well, back to the drawing board. I've very tempted to put a new hole through the firewall with a new grommet.Behind the plastic inner front wing on drivers side RHD vehicle is an unused factory grommet in the firewall, possibly for winch control
Where are you looking?
just a little too short 
