subwoofer

Since I removed the aftermarket subwoofer and bracket and installed a sub enclosure under the rear right seat, I needed a place for the amplifier. I reused the bracket that is attached to the JBL Nano, but just to top of it that is 4 metal "legs" and a flat surface. I placed that under the...

This is a really tight fit. I mean there was a rubber mallet used to pusuade it to get in place tight fit, but it does fit with no damage to the enclosure or the vehicle. The factory subwoofer and brackerts were removed as well as the plastic trim piece on the right side. This is the...

The factory subwoofer is attached to a steel bracker that effectively takes up the entire space under the right rear passenger seat. That prevents installing a second battery, a compressor or in my case a small subwoofer enclosure. After removing the JBL Nano and the bracket it was attached...

Hi, I am in the middle of deciding on an amp to add to my audio system to drive a 10” subwoofer box 500w @ 2ohms. I intend to use the speaker level outputs already pre wired from the factory for the stock JBL subwoofer option. I however after doing some research on the high level inputs of most...

Do we know the location of the harness plug/connector when adding the JBL Nano as DIY install? I have the aux battery but the stock head unit has zero oomph so considering adding the JLB Nano.

Got a new US build about a week ago and I love it. I can’t figure out the radio though. Is it possible to set and view favorite XM radio stations? For the life of me I cannot figure it out. I did find today that you can adjust the subwoofer settings on the sub and make it sound a lot better.